Tags: Power module

Notes: The Happy Ending Kit is an easy way to get everything needed to start a Eurorack modular system.

The Happy Ending Kit includes:
1 x Z-Rails set plus screws to attach to Z-Ears
1 x uZeus 4HP PSU with 2 x flying bus boards
1 x UK 3-pin mains adapter

Notes: The Row Power 25 is a clean, regulated, and protected power supply module for Eurorack systems. It requires a barrel-style power brick (15V - 20V DC) and supplies power to modules via flying bus cables, direct connection, and/or bus boards.

The Row Power 25 provides 25W of power for any Eurorack modules (typically 4-10 modules*):

+12V @ 1.4A maximum, 1.0A recommended
-12V @ 0.8A maximum, 0.5A recommended
+5V @ 1.0A maximum, 0.8A recommended

*number of modules can vary depending on each module's power consumption.

Simply plug a universal power supply (laptop style) into either of the barrel plugs on the 4HP panel. Connect your modules via flying-bus cables or the Bus Stick.

Multiple Row Power modules can be powered from a single power brick by daisy-chaining with an inexpensive barrel cable. The Row Power 25 can also be daisy-chained to Pods. Each Row Power and Pod will be independently regulated and protected for ultra-low cross-talk between rows.

Notes: 2hp Power supply + Dual Passive Mult

Portable 2hp power module for compact skiff cases with dual passive multiples

12 to 20V DC input
Up to 1A from +12V
Up to 700mA from -12V via flying bussboard

Power consumption:

0 mA +12V
0 mA -12V
0 mA 5V

Dimensions:

2 HP
42 mm deep

Notes: This is a revision 02 of ADDAC's Power Starvation module.

It provides an "ideal" way to power starve other modules, starving modules means the modules will receive less voltage than the standard +/-12V supply.

Power starvation is the first hack that any "DIY'er" learns. It's also one of the hacks that can generate some of the most interesting sonic effects in circuit bending.

Plug any module below +/-200mA through it and independently tune it's supply power. This will have most interesting effects in analog modules: filters, delays, mixers... They can either go silent or start screaming at your ears, going berserk with the lack of current to behaving normally, making them cough, choke... Something like a safely induced heart attack...

While revision 01 was a simple circuit with pot working as a voltage divider, this upgraded version uses a DC to DC converter that receives its input from the +12V power rail and outputs a bipolar 15V supply. This DC-DC converter also offers short circuit and overcurrent protection. The +/-15V lines are then sent through variable analog voltage regulators that can output a range of 2.5V to 13.5V.

In other words, the module features a +/-200mA PSU with variable voltage outputs.

Safety disclaimer:

While using ADDAC300 should be safe for any module, there may be specific modules where its use may not be advised.

!! Use at your own risk !!

ADDAC System won't be responsible for any issue that may arise while using ADDAC300 power starvation.

If in doubt contact ADDAC prior to any connection.

Tech Specs:

6HP
4.5cm deep

UP TO 600mA +12V (Depending on the starving module connected)
0mA -12V