Back in stock: Studio Equipment

Notes: Two channel expander for Bartender

Mixer section

Each channel has the following:

Stereo or mono - Each channel can be treated as a stereo channel or a mono channel with two summed inputs.

CV inputs for both panning and level control

Two send buses - You can route each channel to one of two send buses. Each send bus is stereo. You can choose if you want the send to come before or after the level/panning controls.

Mute - The mute has both latching mute (up) and a momentary mute (down). The mute uses a capacitor to slow the turn off and on of the mute action. So it is mostly click-less, but you may find an occasional pop.

Cue bus - You can route each channel to the cue bus.

Expandable Mixer Series

Bartenders can be cascaded to create 8ch, 12ch, or 16ch mixer. The main level is what is sent the main level control can act as a group control.

Barbacks can be added to add 2ch to your mix. Barbacks can also be cascaded enabling up to a 16ch mixer configuration.

Send-VCA can be added for CV control of the level of the send.

DVCA, Cast Iron, Mingles, and USB-2CH can all be connected with Dupont cables (aka female to female breadboard cables) via pin headers on the back of the modules. Connecting the in and out pins will send/receive the audio into the next module.

Width: 10hp
12V: 125mA
-12V: 100mA

Notes: The Vermona MEX3 is a midi extension for the meloDICER sequencer and allows the sequencing of synthesizers outside the modular system.

Features:

MIDI output of sequences
Sequences can now be polyphonic with up to three voices
meloDICER can receive MIDI Control Change messages to remotely control all parameters.
All meloDICER controls can send MIDI Control Change messages
Direct synchronisation to a MIDI clock including shuffle conversion (e.g. from a Multiclock)
MeloDICER converts the MIDI real-time messages START, STOP and CONTINUE.
Module width: 4 TE
Power supply via meloDICER

Included in delivery:

MEX3
Connection cable to meloDICER
2 x MIDI cable DIN-3.5mm; 150 cm (Type A)
To use the meloDICER with the MEX3, the latest firmware must be installed. This can be downloaded from the manufacturer's website.

Notes: DPLR is a delay module with two interactive delay lines, each with 750ms of delay time.

One input is split into two delays which share the total delay time (DELAY) and regeneration (REGEN). Side B has control over its delay offset (SPREAD) from side A.

Delay, Spread and Regen are all voltage controlled. Regen at max will echo indefinitely and can create interesting noise swashes.

The top knob toggles through seven different crosstalk configurations (Regen isolated by ping-pong). Press and hold to cycle through four different Regen Filter settings, from very bright to dark.

Two interactive delay lines
750mS delay time
Voltage controlled parameters
Seven crosstalk configurations
Four regen filter settings
Adjustable wet or wet/dry via jumper setting

Power consumption: 67mA at +12 V and 31mA at -12 V
Depth: 45
4 HP