Audio Innovate

Notes: Upgrade your Hercules T7 so it becomes a true scratching machine! With this you get 3 mini Innofader Plus faders already soldered to a board which drops straight into the Hercules T7. No soldering or adjustments needed for installation...faders are already pre-adjusted for tight cut-in < 1.0mm. User accessible calibration buttons on all 3 faders allow for further precision adjustments. Also includes a sleek see-through acrylic mounting plate.

Notes: The new mini innoFADER PRO can turn any ordinary mixer or controller into a true scratch machine for minimal cost. This model is specific for the Stanton STX portable turntable and comes setup to just drop in and go.

The mini Innofader Pro for Stanton STX allows you to toggle between left or right handed cutting setups on the fly. It is the perfect companion for your nano or an ideal upgrade, offering the same precision cutting action.

Each kit comes with two blue with white stripe Coolorcaps so you can match both Innofader caps to the pitch slider cap for a sleek look, plus a matching mounting plate and mini Innofader Pro mounting screws.

The mini innoFADER PRO offers unparalleled precision and adjustability. It can respond to DJ movements in less than a millisecond. DJs can get the dead space down to 0.1mm for super tight and fast cuts, or go to 1mm or so for clean beat juggling. The mini Innofader Pro comes standard with either light tension for scratching.

Features:

0.8msec max latency
0.8msec response time
0.1mm cut-in/cut-out overlap
Adjustable Cut-in 0.0 to 3.2mm
<30 grams friction resistance
0-150 ohm output
Plug and play with the Stanton STX
Unmatched product life
Non-contact variable capacitor technology
100% resistant to dust, smoke, temperature and moisture

Notes: Compatible with the Innofader Pro2, Innofader PNP3, and mini Innofader Plus, the InnoJuster is a smart little module which allows you to adjust cut-in, curve and calibration of your Innofader with it installed in your mixer or controller.

Supplier's notes:
The Innojuster is back by popular demand! The new Innojuster has all of the parts needed to work with the current models Innofader Pro2, Innofader PNP3, and mini Innofader Plus.

The Innojuster allows you to do all of the adjustments, calibrations, and presets with your Innofader fully installed. You may find this especially helpful if you frequently do fine tuning and want the flexibility to do this without opening your mixer or controller each time. Includes the following controls:

1) Cut-in: Allows adjustment of the dead space on each side of the crossfader.
2) Curve: Allows a full range of curve adjustments from bottom to top cut and everything in-between.
3) Fwd/Rev switch: Switches between normal and hamster style fader operation
4) Calibration: Allows recalibration of the Innofader on-the-spot and access to all of the fader presets.

**Note on the mini Innofader Plus the Cut-In and Curve dials adjust left and right cut points independently.

On the Innofader PNP3 and Innofader Pro2, you have the flexibility of using the standard dial functions or separate left/right cut point adjustments.